Spypoint TINY-W3 Manual de usuario descargar pdf (Pagina 24)

Setup • Receiver (BLACKBOX)

Note: In the minute following turning on the receiver, the test light of the

receiver ashes. The rst 8 seconds allows the user to know the battery

status (p.11). Then for the rest of the time, the test light ashes rapidly

to indicate the synchronization period.

Note: After a synchronization or when the test light turns off (after 60

seconds), the receiver can’t be synchronized unless it is turned off and

on again.

MANUALLY SYNCHRONIZING ONE OR MULTIPLE SETS (TINY-W

CAMERA/BLACKBOX RECEIVER) IN THE SAME PERIMETER

To change the synchronization channel or to install one or many sets

(TINY-W

/BLACKBOX

receiver) in the same area of transmission, it is

necessary to manually synchronize each camera with its receiver on a

different channel.

1. Turn on the rst camera and choose the SIGNAL mode.

2. Turn on the rst BLACKBOX

receiver.

3. Choose the

Channel

option on the camera and press OK.

4. Use the  and  buttons to select a channel and press OK.

5. Choose the

Sync

option on the camera and press OK.

6. The camera synchronizes with the powered receiver and the

icon Sync goes from red to green when the synchronization

is complete.

7. Turn off the camera and the corresponding receiver.

8. Repeat these steps for each additional set, up to 9 sets (TINY-W

/BLACK-

BOX

receiver) can be matched in a same perimeter of 250ft.

Sync

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 53 54

Sin comentarios

Spypoint TINY-W3 Manual de usuario Pagina 24